93
Chapter 12 - Troubleshooting
Error Code Description of Error Solution
#50
A non-specific trolley error has
occurred
• Close the error dialog screen
• Retry the action
If the Error Code is displayed again then the
Vector Elite system requires power cycling to
reboot:
• Turn the power off
• Turn the power back on
• Restart the Vector Elite software application
If the Error Code is displayed again after
rebooting, stop using the system and call Bioness
at 800.211.9136, option 3 (in the United States)
or your local distributor (outside of the United
States) for troubleshotting assistance.
#55
A non-specific trolley error has
occurred
#81 Trolley firmware error
#87 Watchdog error
#92 WiFi interlock error
#90 Internal networking trolley error
#98 Trolley servo error
#99 Winch servo error
#88 Winch motor controller error
#89 Trolley motor controller error
Table 12-2: Error Code Descriptions
Error Code Description of Error Solution
#56 A non-specific trolley error
The Vector Elite system requires power cycling to
reboot:
• Turn the power off
• Turn the power back on
• Restart the Vector Elite software application
#93 Contractor error
#94
Hardware interlock for the
winch has tripped
Table 12-3: Additional Error Code Descriptions
To Next Page
Loading...
