73
Chapter 9 - Vector Elite Remote Control
Walk Test
1. On the remote control, select the Take Control tab and press the Take Control button.
2. On the remote control, select the Walk tab.
3. From the Walking Test screen, use the drop-down menu to choose the appropriate test:
• 5 meter, fast
• 5 meter, comfortable
• 10 meter, fast
• 10 meter, comfortable
• 6 minute
• 2 minute
4. For the 5 or 10 Meter Walk Test: When the patient has accelerated to their comfortable/fast
walking pace, press the Start button. See Figure 9-22. If you have placed markers, press the Start
button when the patient's front foot crosses the 2-meter mark.
• The test collection will continue and automatically stop when a distance of 5 or 10 meters has
been walked. Instruct the patient to stop walking.
5. For the 2 or 6 Minute Walk Test: Press the Start button when the patient begins to walk. The
patient must continuously walk as far as possible during a 2 or 6 minute period.
• The test collection will continue and automatically stop when a time of 2 or 6 minutes has been
reached. Instruct the patient to stop walking.
6. To adjust the training controls during a Walking Test, swipe back to the Training Controls tab.
7. Make the desired adjustments to the training controls. Swipe to the right on the tabs and select the
Walk Test tab to return to the Walking Test screen.
Note: The training controls are only accessible by the device that is in control.
8. The test will automatically stop at the selected distance or time. To cancel the test at any time, use
the Stop button. See Figure 9-23.
9. Return to the PC to review test results, fill in assessments, and save the test. The test can also be
saved as a baseline or exported as a screen capture from the PC.
Note: To save the test results, you must press the Save button on the PC.
To Next Page
Loading...
