Bionet BM5 - WAVEFORM SCALE (Measured Waveform Scale Setting); Zero

Rev 3.1 10. EtCO2 171
BM5 (CS,CX) User’s Manual
> 6.25mm/s
12.5mm/s
25mm/s
APNEA
DETECT:
ON
ALARM
SWEEP
SPEED:
6.25mm/s
MAIN
MENU
WAVEFORM SCALE (Measured waveform scale setting)
This sets the range of measured waveform versus pressure.
Selectable numerical value means the maximum pressure range value that is shown with waveform.
Pressing the knob switch key and then selecting the desired range value displays the selected
pressure range value below the upper dotted line among two dotted lines in the left middle of wave
window.
ZEROSETTINGS
APNEA
DETECT:
OFF
ALARM
SWEEP
SPEED:
6.25mm/s
WAVEFORM
SCALE:
40mmHg
MAIN
MENU
> 40mmHg
50mmHg
60mmHg
80mmHg
100mmHg
APNEA
DETECT:
OFF
ALARM
WAVEFORM
SCALE:
40mmHg
MAIN
MENU
ZERO
When a new sensor is connected, the message “ZERO REQUEMENT” is displayed.
This is required anytime a new sensor is connected to the monitor.
SETTINGS
ZERO
APNEA
DETECT:
OFF
ALARM
SWEEP
SPEED:
6.25mm/s
WAVEFORM
SCALE:
40mmHg
MAIN
MENU