Bionet BM5 - Default Setting Values

Rev. 3.1 13. MESSAGE LIST
192
BM5 (CS,CX) User’s Manual
13. MESSAGE LIST
Function
Message
Details
ECG
LEAD FAULT
Cable is not properly connected.
SpO2
CHEK PROBE
LEAD FAULT
Patient’s finger is off the probe.
Cable is not properly connected.
RESP
LEAD FAULT
APNEA
Cable is not properly connected.
APNEA gives an alarm.
NIBP
INFLATION FAILURE CHECK CUFF
OVER PRESSURE
DEFLATION FAILURE CHECK CUFF
OVER TIME CUFF PRESSURE
MEASUREMENT ERROR
Cuff hose is not properly connected.
Cuff pressure is putting on excessively.
Cuff is bent, preventing deflation.
Measure time exceeds the preset Level.
Measure signal absent
TEMP
LEAD FAULT
Cable is not properly connected.
IBP
CHECK SENSOR
DISCONNECTED
IMBALANCE
Cable is not properly connected.
Cable is not properly connected or low
pressure
Device isn’t zero adjustment
EtCO2
MODULE OFF
SENSOR WARMUP
CHECK ADAPTOR
CHECK LINE
APNEA
ZERO IN PROGRESS
SENSOR FAULTY
Module is not connected.
Sensor initialization.
Adaptor is not properly connected.
Tube is not properly connected.
The APNEA alarm occurs.
Zero adjustment is progress.
Poor sensor measurement.
ALARM
ALARM VOL.OFF
SILENCED
ALARM PAUSE 5MIN
Alarm volume is off.
Alarm key is pressed once
Alarm key is pressed twice
TREND
NO PATIENT DATA
No patient’s data input.