Rev. 3.1 1.BASIC
BM5 (CS,CX) User’s Manual
General Precaution on Electric Safety
BM5 OPERATION MANUAL
Check the item listed below before operating the equipment.
NOT
1. Be sure that AC power supply line is appropriate to use. (AC100 - 240V)
2. Be sure that the power source is the one supplied from Bionet. (DC18V, 2.5A, MW160KA1803)
3. Be sure that the entire connection cable of the system is properly and firmly fixed.
4. Be sure that the equipment is completely grounded. (If not, there might be the problem occur in
the product.)
5. The equipment should not be placed in the vicinity of electric generator, X-ray, broadcasting
apparatus to eliminate the electric noise during operation. Otherwise, it may cause incorrect result.
The Equipment should be placed far from generator, X-ray equipment, broadcasting equipment
or transmitting wires, so as to prevent the electrical noises from being generated during the
operation, When these devices are near the Equipment, it can produce inaccurate
measurements. For BM5 (CS, CX) both independent circuit and stable grounding are
essentially required. In the event that the same power source is shared with other electronic
equipment, it can also produce inaccurate output.
Do not contacts with the patient while operate the machine It may cause serious danger to the
users. Use only the provided cable.
A warning that other cables and accessories may negatively affect EMC performance
In case the Equipment does not operate as usual or damaged, do not use on patient, and
contact to the medical equipment technician of the hospital or the equipment supply division.
To Next Page
Loading...
