Bionet BM5 - Manufacturers Declaration - Electromagnetic Emission

Rev. 3.1 1.BASIC
19
BM5 (CS,CX) User’s Manual
Note
BM5 (CS, CX) is classified as follows:
- BM5 (CS, CX) classifies as Class I, BF & CF concerning electric shock. It is not proper to
operate this Equipment around combustible anesthetic or dissolvent.
- Noise level is B class regarding IEC/EN 60601-1 and the subject of Nose is B level concerning
IEC/EN60601-1-2.
Equipment Connection
For measurements in or near the heart we recommend connecting the monitor to the potential
equalization system. Use the green and yellow potential equalization cable and connect it to the pin
labeled with the symbol .
Manufacturer’s declaration - electromagnetic emission
The BM5 system is intended for use in the electromagnetic environment specified below. The
customer or the user of BM5 system should assure that it is used in such an environment
Emission test
Compliance
Electromagnetic environment - guidance
RF emissions
CISPR 11
Group 1
The BM5 system uses RF energy only for its
internal function. Therefore. Its RF emissions are
very low and are not likely to cause any
interference in nearby electronic equipment
RF emissions
CISPR 11
Class B
The BM5 system is suitable for use in all establi
shments other than domestic and those directly
connected to the public low-voltage power sup
plies buildings used for domestic purposes.
Harmonics emission
IEC 61000-3-2
A
Voltage fluctuation
IEC 61000-3-3
Complies