Bionet BM5 - ECG Data Window and Heart Rate

Rev. 3.1 5.ECG 96
BM5 (CS,CX) User’s Manual
5.2 ECG Data Window
Note
ECG Wave Display is always on when the cable is connected.
The heart rate is calculated by a moving average. The monitor detects 8 consecutive beats,
averages the R-R intervals of the latest 8 beats and uses this average to calculate the current
heart rate. When a new beat is detected, the heart rate is recalculated using the latest 8beats. The
heart rate display is updated every 3 seconds.
Heart rate meter updates a new heart rate for a step increase or decrease in 10 seconds maximum.
When ventricular tachycardia is detected, the alarm set in 5 seconds maximum.
Check that the delay time of the output signal (alarm trigger 80ms maximum) is within the range of
the connected equipment.
80
50
100
P
BPM
Heart Rate Alarm Limit:
Decides the QRS limits, and
gives an alarm if a value is over
the limits.
QRS: Detects QRS, and
flashes when QRS is
detected.
Heart Rate:
Displays heart rate per minute.
Pace Detector
Indicators:
Detects and displays
the patient’s pace
maker and flashes.