Bionet BM5 - Module Reset; Apnea Detect

Rev 3.1 10. EtCO2 176
BM5 (CS,CX) User’s Manual
MODULE RESET
This command is used to cause a system watchdog reset in the sensor. When this command is
issued, the system enters an infinite loop and a watchdog timer resets the system one second later.
MODULE
SETUP
MODULE
INFO
MODULE
RESET
PREV
MENU
MAIN
MENU
APNEA DETECT
Turn the APNEA detection alarm off and on
ZERO
APNEA
DETECT:
OFF
ALARM
SWEEP
SPEED:
6.25mm/s
WAVEFORM
SCALE:
40mmHg
MAIN
MENU
SETTINGS
APNEA ALARM: This performs a function to set the display of apnea message alarm.
This displays a “apnea” message at the center of parameter window as shown in the figure below
with apnea alarm on in case of apnea until the set apnea period is passed through.
EtCO2
20S
50
30
APNEA
With apnea alarm off, measured values are displayed instead of message.
25
50
30S
0
EtCO2
0 0
/
EtCO2FiCO2