16 MT55 Operation & Maintenance Manual
FIRE PREVENTION (CONT’D)
Hydraulic System
Check hydraulic tubes, hoses and fittings for damage
and leakage. Never use open flame or bare skin to check
for leaks. Hydraulic tubes and hoses must be properly
routed and have adequate support and secure clamps.
Tighten or replace any parts that show leakage.
Always clean fluid spills. Do not use gasoline or diesel
fuel for cleaning parts. Use commercial nonflammable
solvents.
Fueling
Stop the engine and let it cool before adding fuel. No
smoking! Do not refuel a machine near open flames or
sparks. Fill the fuel tank outdoors.
Ultra Low Sulfur Diesel (ULSD) poses a greater static
ignition hazard than earlier diesel formulations with
higher Sulfur content. Avoid death or serious injury from
fire or explosion. Consult with your fuel or fuel system
supplier to ensure the delivery system is in compliance
with fueling standards for proper grounding and bonding
practices.
Starting
Do not use ether or starting fluids on any engine that has
glow plugs. These starting aids can cause explosion and
injure you or bystanders.
Use the procedure in the Operation & Maintenance
Manual for connecting the battery and for jump starting.
Spark Arrester Exhaust System
The spark arrester exhaust system is designed to control
the emission of hot particles from the engine and exhaust
system, but the muffler and the exhaust gases are still
hot.
Check the spark arrester exhaust system regularly to
make sure it is maintained and working properly. Use the
procedure in the Operation & Maintenance Manual for
cleaning the spark arrester muffler (if equipped).
Welding And Grinding
Always clean the machine and attachment, disconnect
the battery, and disconnect the wiring from the Bobcat
controllers before welding. Cover rubber hoses, battery
and all other flammable parts. Keep a fire extinguisher
near the machine when welding.
Have good ventilation when grinding or welding painted
parts. Wear dust mask when grinding painted parts.
Toxic dust or gas can be produced.
Dust generated from repairing nonmetallic parts such as
hoods, fenders or covers can be flammable or explosive.
Repair such components in a well ventilated area away
from open flames or sparks.
Fire Extinguishers
Know where fire extinguishers and first aid kits are
located and how to use them. Inspect the fire
extinguisher and service the fire extinguisher regularly.
Obey the recommendations on the instructions plate.
Sl ML-0913
Dealer Copy -- Not for Resale
To Next Page
Loading...