52 MT55 Operation & Maintenance Manual
OPERATING PROCEDURE (CONT’D)
Digging And Filling A Hole (Cont’d)
Filling
Figure 65
Move the Lift Arm / Attachment Tilt Control Lever forward
(Item 1) [Figure 65] to lower the lift arms.
Move the Lift Arm / Attachment Tilt Control Lever to the
right (Item 2) [Figure 65] to put the bucket cutting edge
on the ground. Drive forward to the edge of the hole to
push the material into the hole.
Move the Lift Arm / Attachment Tilt Control Lever to the
right (Item 2) [Figure 65] to tilt the bucket forward as
soon as it is past the edge of the hole.
If necessary, raise the lift arms to empty the bucket.
AVOID INJURY OR DEATH
Falling loads can cause serious injury or death.
Keep load level when raising lift arms.
W-2623-1104
TOWING THE MINI TRACK LOADER
Procedure
Because of the design of the mini track loader, there is
not a recommended towing procedure.
• The mini track loader can be lifted onto a transport
vehicle.
• The mini track loader can be skidded a short distance
to move for service (EXAMPLE: Move onto a
transport vehicle.) without damage to the hydrostatic
system. (The tracks will not turn.) There might be
slight wear to the tracks when the mini track loader is
skidded.
The towing chain (or cable) must be rated at 1.5 times
the weight of the mini track loader. (See Performance
on Page 112.)
Dealer Copy -- Not for Resale
To Next Page
Loading...