48 MT55 Operation & Maintenance Manual
OPERATING PROCEDURE (CONT’D)
Driving With An Auger Attachment Installed
AVOID INJURY OR DEATH
Never use attachments or buckets which are not
approved by Bobcat Company. Buckets and
attachments for safe loads of specified densities are
approved for each model. Unapproved attachments
can cause injury or death.
W-2052-0907
The swing stop kit must be installed on the auger before
installing on the mini track loader. Drive slowly with the
auger installed. Always carry the auger as low as
possible. Only light duty auger bits are approved by
Bobcat Company for use on the mini track loader. (Light
duty auger bits are factory painted white.)
Figure 53
The auger swing stop kit (Item 1) [Figure 53] (Kit P/N
6811444) must be installed on the auger before using
this attachment on the mini track loader.
Figure 54
When driving the mini track loader with the auger
installed, always have the Bob-Tach rolled back fully
[Figure 54].
Lower the mini track loader arms [Figure 54] so that the
auger bit is just off the ground. Slow down when traveling.
See the Direct Drive Auger Operation & Maintenance
Manual for additional information.
Dealer Copy -- Not for Resale
To Next Page
Loading...