94 MT55 Operation & Maintenance Manual
MINI TRACK LOADER STORAGE AND RETURN TO SERVICE
Storage
Sometimes it may be necessary to store your Bobcat
Mini Track Loader for an extend period of time. Below is a
list of items to perform before storage.
• Thoroughly clean the mini track loader including the
engine compartment.
• Lubricate the mini track loader.
• Replace worn or damaged parts.
• Drive the mini track loader onto planks in a dry
protected shelter.
• Lower the lift arms fully with the bucket flat on the
ground.
• Put grease on any exposed cylinder rods.
• Put fuel stabilizer in the fuel tank and run the engine
a few minutes to circulate the stabilizer to the pump
and fuel injectors.
• Drain and flush the cooling system. Refill with
premixed coolant.
• Replace all fluids and filters (engine, hydraulic).
• Replace all filters (i.e.: air cleaner, oil, etc.).
• Put all controls in NEUTRAL position.
• Remove the battery. Be sure the electrolyte level is
correct then charge the battery. Store it in a cool dry
place above freezing temperatures and charge it
periodically during storage.
• Cover the exhaust pipe opening.
• Tag the machine to indicate that it is in storage
condition.
Return To Service
After the Bobcat Mini Track Loader has been in storage, it
is necessary to follow a list of items to return the mini
track loader to service.
• Check the engine and hydraulic oil levels; check
coolant level.
• Install a fully charged battery.
• Remove grease from exposed cylinder rods.
• Check all belt tensions.
• Be sure all shields and guards are in place.
• Lubricate the mini track loader.
• Remove cover from the exhaust pipe opening.
• Start the engine and let run for a few minutes while
observing the instrument panels and systems for
correct operation.
• Drive the mini track loader off of the planks.
• Operate machine, check for correct function.
• Stop the engine and check for leaks. Repair as
needed.
Dealer Copy -- Not for Resale
To Next Page
Loading...