Bobcat MT55 - Warming The Hydraulic; Hydrostatic System

37 MT55 Operation & Maintenance Manual
PRE-STARTING PROCEDURE
Procedure
Figure 31
Read and understand the Operation & Maintenance
Manual stored inside the rear door before operating the
mini track loader (Item 1) [Figure 31].
WARNING
Instructions are necessary before operating or
servicing machine. Read and understand the
Operation & Maintenance Manual and signs (decals)
on machine. Follow warnings and instructions in the
manuals when making repairs, adjustments or
servicing. Check for correct function after
adjustments, repairs or service. Failure to follow
instructions can cause injury or death.
W-2406-0801
Figure 32
Put the controls in NEUTRAL “N” position [Figure 32].
Figure 33
Engage the parking brake (Item 1) [Figure 33].
Stand behind the mini track loader in the operator's
position.
WARNING
AVOID INJURY OR DEATH
When operating the machine:
• Operate only from the operator’s position at the
rear of the loader.
• Always keep your hands on the controls.
• Stay away from the tracks.
W-2407-0801
WARNING
AVOID INJURY OR DEATH
• Movement of the attachment will occur if the tilt
control is NOT in neutral when the engine is
started.
• Always check that all levers are in neutral before
starting the engine.
W-2482-1003
NOTE: The engine will not start unless the Drive /
Steering Control and the Auxiliary Hydraulic
Control Lever are in NEUTRAL and the
Continuous Flow Shutoff Lever is in the UP
position.
P-81895
1
P-81916
N
N
N
N
P-81910
1
39 of 122
Dealer Copy -- Not for Resale