81 MT55 Operation & Maintenance Manual
ELECTRICAL SYSTEM (CONT’D)
Removing And Installing The Battery
AVOID INJURY OR DEATH
Batteries contain acid which burns eyes and skin on
contact. Wear goggles, protective clothing and
rubber gloves to keep acid off body.
In case of acid contact, wash immediately with water.
In case of eye contact get prompt medical attention
and wash eye with clean, cool water for at least 15
minutes.
If electrolyte is taken internally drink large quantities
of water or milk! DO NOT induce vomiting. Get
prompt medical attention.
W-2065-0807
Open the rear door.
Figure 102
Disconnect the negative (-) battery cable (Item 1)
[Figure 102].
Disconnect the positive (+) battery cable (Item 2)
[Figure 102].
Remove the battery hold-down clamp (Item 3)
[Figure 102].
Remove the battery from the mini track loader.
Figure 103
Always clean the battery terminals and cable ends when
installing a new or used battery [Figure 103].
When installing the battery in the mini track loader, do not
touch any metal parts with the battery terminals.
Connect the negative (-) cable last to prevent sparks.
Connect and tighten the battery cables.
Close the rear door before operating the mini track
loader.
Dealer Copy -- Not for Resale
To Next Page
Loading...