80 MT55 Operation & Maintenance Manual
ELECTRICAL SYSTEM (CONT’D)
Using A Booster Battery (Jump Starting)
AVOID INJURY OR DEATH
Batteries contain acid which burns eyes and skin on
contact. Wear goggles, protective clothing and
rubber gloves to keep acid off body.
In case of acid contact, wash immediately with water.
In case of eye contact get prompt medical attention
and wash eye with clean, cool water for at least 15
minutes.
If electrolyte is taken internally drink large quantities
of water or milk! DO NOT induce vomiting. Get
prompt medical attention.
W-2065-0807
If it is necessary to use a booster battery to start the
engine, BE CAREFUL! The key switch must be OFF
when connecting jumper cables. The booster battery
must be 12 volt.
BATTERY GAS CAN EXPLODE AND CAUSE
SERIOUS INJURY OR DEATH
Keep arcs, sparks, flames and lighted tobacco away
from batteries. When jumping from booster battery
make final connection (negative) at machine frame.
Do not jump start or charge a frozen or damaged
battery. Warm battery to 16°C (60°F) before
connecting to a charger. Unplug charger before
connecting or disconnecting cables to battery. Never
lean over battery while boosting, testing or charging.
W-2066-0910
Figure 101
Connect the end of the first cable (Item 1) [Figure 101] to
the positive (+) terminal of the booster battery. Connect
the other end of the same cable (Item 2) [Figure 101] to
the positive terminal on the mini track loader battery.
Connect the end of the second cable (Item 3)
[Figure 101] to the negative (-) terminal of the booster
battery. Connect the other end of the same cable (Item 4)
[Figure 101] to the mini track loader frame.
Keep cables away from moving parts. Start the engine.
After the engine has started, remove the ground (-) cable
(Item 4) [Figure 101] first.
Remove the cable from the positive terminal (Item 2)
[Figure 101].
Damage to the alternator can occur if:
• Engine is operated with battery cables
disconnected.
• Battery cables are connected when using a fast
charger or when welding on the loader. (Remove
both cables from the battery.)
• Extra battery cables (booster cables) are
connected wrong.
I-2023-1285
Dealer Copy -- Not for Resale
To Next Page
Loading...