50 MT55 Operation & Maintenance Manual
OPERATING PROCEDURE (CONT’D)
Filling The Bucket And Emptying The Bucket
Filling
Figure 59
Move the Lift Arm / Attachment Tilt Control Lever forward
(Item 1) [Figure 59] until the lift arms are all the way
down.
Move the lever to the right (Item 2) [Figure 59] to put the
cutting edge of the bucket on the ground.
Figure 60
Drive slowly forward into the material and move the lever
to the left (Item 1) [Figure 60] to raise the front of the
bucket.
Drive backward away from the material.
Raise the bucket only high enough to avoid obstructions
on rough ground.
Load, unload and turn on flat level ground. Do not
exceed rated operating capacity shown on sign
(decal) on the machine. Failure to obey warnings can
cause the machine to tip and cause injury or death.
W-2420-0102
Emptying the Bucket
Figure 61
Move the Lift Arm / Attachment Tilt Control Lever
backward (Item 1) [Figure 61] to raise the lift arms. Move
the lever to the right (Item 2) [Figure 61] while raising the
lift arms to level the bucket or attachment and help
prevent material from falling off the back of the bucket or
attachment.
Drive forward slowly until the bucket is over the top of the
truck box or bin.
Move the lever to the right (Item 2) [Figure 61] until the
bucket is empty. If all the material is near the side of the
truck or bin, push it to the other side with the bucket.
AVOID INJURY OR DEATH
Falling loads can cause serious injury or death.
Keep load level when raising lift arms.
W-2623-1104
Dealer Copy -- Not for Resale
To Next Page
Loading...