64 MT55 Operation & Maintenance Manual
LIFT AND TILT FUNCTION LOCKOUTS
Inspection
1. Stand at the operator's position behind the mini track
loader and start the engine.
2. Raise the lift arms about 914 mm (3 ft) off the ground.
3. Turn the key OFF and wait for the engine to come to
a complete stop. Engage the parking brake.
4. Make sure the area around the machine is clear of
bystanders.
Figure 71
5. Move the Lift Arm / Attachment Tilt Control Lever
forward to lower the lift arms (Item 1) [Figure 71]. The
lever must not
move and the lift arms must not lower.
6. Move the Lift Arm / Attachment Tilt Control Lever right
to tilt the bucket (or attachment) forward (Item 2)
[Figure 71]. The lever must not
move and the bucket
must not
tilt forward.
NOTE: See your Bobcat dealer for repair if the lift / tilt
lockout does not function properly.
The Reverse Stop Panel, Neutral Start Interlocks, and
Lift / Tilt Lockouts must function properly.
• The Reverse Stop Panel must stop mini loader
from moving backward when panel is pushed
forward.
• The Lift / Tilt Lockouts must deactivate the lift
and tilt functions when engine is off.
If any of these do not function properly, contact your
dealer for service. DO NOT modify system.
W-2559-0207
Dealer Copy -- Not for Resale
To Next Page
Loading...