Boeing 787-8 - Page 1289

787 Flight Crew Operations Manual
DO NOT USE FOR FLIGHT
Flight Management, Navigation -
FMC Preflight
Copyright © The Boeing Company. See title page for details.
D615Z003-TBC 11.40.43
Displays the takeoff runway from the active RTE page if previously selected.
Runway entry does not change runway entered on RTE or DEPARTURES page.
Flight crew may enter or uplink runway and intersection data.
Valid entry of a runway intersection is an alphanumeric up to three characters,
preceded by a slash (/).
[Option – Runway position shift, English units]
Valid position entry is a one or two numeric in the range 0-99. It must be followed
by two zeros and preceded by a slash (preceding the entry with a “-”means a
longer takeoff distance is available; for example, -0300 is 300 feet before the
runway threshold).
Entry of a value after takeoff speeds have been accepted deletes takeoff speeds and
displays the CDU help window message TAKEOFF SPEEDS DELETED.
RWY/POS update inhibited when GPS is primary FMC navigation source.
Push – transmits a company datalink request for takeoff data.
Flight crew can enter RWY, intersection or position shift, CG, TOGW, or OAT to
qualify the request.
Push – displays the INIT/REF INDEX page.
Dashes display when:
• required information not entered
• IRS not aligned
EFB calculated speeds display in small font. The takeoff data comes from the EFB
performance page and is sent as an uplink to the FMC after the pilot initiates
“Send to FMC” from the EFB.
Flight crew entered speeds display in large font and replace EFB uplinked or AOC
uplinked speeds. The following applies to manually entered or accepted uplinked
speeds:
• V1 speeds less than V1MIN are indicated by display of “MIN V1” in the
header line and the value of V1MIN in the data line
• VR speeds less than V1MIN or VRMIN are indicated by display of “MIN”
in the header line and the greater value of V1MIN or VRMIN in the data
line
• V2 speeds less than V2MIN or V2MINA are indicated by display of
“MIN” in the header line and the greater value of V2MIN or V2MINA in
the data line
Push –
• crew entered V speeds replace EFB uplinked or AOC uplinked speeds
5
TAKEOFF DATA REQUEST
6
INDEX
7
V Speeds (V1, VR, V2)
June 16, 2008