787 Flight Crew Operations Manual
DO NOT USE FOR FLIGHT
Supplementary Procedures Chapter SP
Flight Instruments, Displays Section 10
Copyright © The Boeing Company. See title page for details.
D615Z003-TBC SP.10.1
SP.10 Supplementary Procedures-Flight Instruments, Displays
[Option – QFE]
Supplementary Procedures
SP.10 Flig ht Instrumen ts, DisplaysFlight Instruments, Displays
QFE Operation
This procedure is accomplished when ATC altitude assignments are
referenced to QFE altimeter settings.
Note: Do not use LNAV and/or VNAV below transition altitude/level.
Altitudes in the navigation database are not referenced to QFE.
Use only raw data for navigation.
CDU APPROACH REF page.........................................................Select
LANDING REF key ....................................................................Push
Verify QFE selected.
[This sets the landing altitude to zero.]
Altimeters ........................................................................................... Set
Set altimeters to QFE when below transition altitude/level.
If the QFE altimeter setting is beyond the range of the altimeters, QNH
procedures must be used with QNH set in the altimeters.
August 14, 2009
To Next Page
Loading...
