Control Panels Approved applications | en 103
Bosch Security Systems, Inc. Installation and System Reference Guide 2016.06 | 08 | F.01U.303.996
– Use a separate D8108A for the two 12 V 7 Ah batteries. When using a D122L Dual Battery
Harness, wire the batteries in parallel and connect the harness to the BAT+ and BAT-
terminals of the control panel.
Wiring information for installations using the Rothenbuhler 5110/4001-42 High Security Bell
Refer to the following two figures for wiring information.
Figure19.27: Rothenbuhler 5110 4001-42 High Security Bell to control panel wiring
Callout á…³ Description Callout á…³ Description
1 á…³ Self-contained UL listed vibration sensor 9 á…³ D122/D122L Dual Battery Harness
2
2 á…³ Control panel 10 á…³ D126 Battery
3 á…³ Accessory modules 11 á…³ D8108A Enclosure
4 á…³ High line security module 12 á…³ Proximity/control unit
5 á…³ 4001-42 Balanced Line Module 13 á…³ Normally open (NO)
6 á…³ 5110 Bell 14 á…³ Normally closed (NC)
7 á…³ D133 Relay 15 á…³ End-of-line (EOL) resistor
8 á…³ Alarm input point
1
16 á…³ Safe
1
Use Terminals 1 through 8. (Select only one.)
2
Use a D113 Battery Lead Supervision Module to supervise the battery connections
.
To Next Page
Loading...
