Bosch B9512G - B450 Conettix Plug-In Communicator Interface

Control Panels IP communications | en 55
Bosch Security Systems, Inc. Installation and System Reference Guide 2016.06 | 08 | F.01U.303.996
Flash pattern Function
RX (Receive) Flashing
Occurs when the module receives a message over the
network connection – UPD, TCP, or DNS.
TX (Transmit) Flashing
Occurs when the module sends a message over the
network connection – UPD, TCP, or DNS.
Tab.8.7: RX and TX LEDs descriptions
LINK (yellow) LED pattern 100Mb (green) LED pattern Function
Off Off
No Ethernet link
On Steady
Off
10Base-T link
Flashing
Off
10Base-T activity
On Steady On Steady
100Base-TX link
Flashing
On Steady
100Base-TX activity
Tab.8.8: Ethernet Link LEDs descriptions
8.4 B450 Conettix Plug-in Communicator Interface
The B450 Conettix Plug-in Communicator Interface gives the ability to connect more than one
cellular plug-in communicator to the control panel by providing an interface to the control
panel’s SDI2 wiring.
The B450 supports one cellular plug-in module.
The B450 Conettix Plug-in Communicator Interface connects to the SDI2 bus on the control
panel using terminals 27 through 30 (or 23 through 26 if configured for SDI2), or using the
SDI2 interconnect wiring connector. This section includes basic installation instructions. For
detailed installation instructions, refer to the Conettix Plug-in Communicator Interface (B450)
Installation and Operation Guide.