Bosch B9512G - IP Camera; Cloud

160 en | Keypad Installer menu Control Panels
2016.06 | 08 | F.01U.303.996 Installation and System Reference Guide Bosch Security Systems, Inc.
20.3.4 [4] IP Camera
IP Camera
B91x/B92x keypads use of IP Camera
1. Enter the installer passcode, and then open the [1] Installer menu.
2. Go to [3] Diags Menu > [4] IP Camera. The keypad shows one of the following statuses:
– Not Configured
– Not responding
– Bad Password
– Online
– Missing
3. When finished viewing the information, escape from the menu.
B93x/B94x keypads use of IP Camera
1. Enter the installer passcode, and then open the [1] Installer menu.
2. Go to [3] Diags Menu > [4] IP Camera. The keypad shows one of the following statuses:
– Not Configured
– Not responding
– Bad Password
– Online
– Missing
3. When finished viewing the information, escape from the menu.
20.3.5 [5] Cloud
B91x/B92x keypads use of Cloud (diagnostics)
1. Enter the installer passcode, and then open the [1] Installer menu.
2. Go to [3] Diags > [5] Cloud. The keypad shows the Cloud ID, which is also on a label on
the control panel.
3. Press [NEXT]. The keypad shows the Cloud configuration, which is one of the following:
– Not Available
– Enabled on Ethernet
– Enabled on Cellular
– Enabled on Ethernet and Cellular
4. Press [NEXT]. The keypad shows the Cloud Certificate status, which is one of the
following:
– Not Installed
– Certificate Valid
5. Press [NEXT]. The keypad shows the Cloud state, which is one of the following:
– Connected (and through which method)
– Not Ready
– Disconnected
– Not Available
– Trying to Connect
6. When finished viewing the information, escape from the menu.
B93x/B94x keypads use of Cloud (diagnostics)
1. Enter the installer passcode, and then open the [1] Installer menu.
2. Go to [3] Diags > [5] Cloud. The keypad shows the Cloud ID, which is also on a label on
the control panel.