Control Panels System overview | en 27
Bosch Security Systems, Inc. Installation and System Reference Guide 2016.06 | 08 | F.01U.303.996
Strobe model Product Description
SC24 Series Ceiling-mount
Strobes
SC24115 24 VDC, 115 cd, Red, Ceiling mount
SC24115W 24 VDC, 115 cd, Round, White, Ceiling mount
SC2415 24 VDC, 15 cd, Round, Red, Ceiling mount
SC2415W 24 VDC, 15 cd, Round, White, Ceiling mount
SC241575 24 VDC, 15/75 cd, Round, Red, Ceiling mount
SC241575W 24 VDC, 15/75 cd, Round, White, Ceiling mount
SC24177 24 VDC, 177 cd, Round, Red, Ceiling mount
SC24177W 24 VDC, 177 cd, Round, White, Ceiling mount
SC2430 24 VDC, 30 cd, Round, Red, Ceiling mount
SC2430W 24 VDC, 30 cd, Round, White, Ceiling mount
SC2475 24 VDC, 75 cd, Round, Red, Ceiling mount
SC2475W 24 VDC, 75 cd, Round, White, Ceiling mount
SC2495 24 VDC, 95 cd, Round, Red, Ceiling mount
SC2495W 24 VDC, 95 cd, Round, White, Ceiling mount
Notice!
Use of 24 V devices requires the use of a UL1481 regulated power-limited power supply and a
D130 Relay Module. Refer to the D130 Installation Instructions.
3.3 Features
This section includes the control panel's notable features.
3.3.1 SDI2 interconnect wiring
Most SDI2 modules include one or two interconnect wiring connectors. You can use these
connectors to connect the modules to the control panel, and then to each other, without
having to connect wires individually to the SDI2 terminals. For installations using multiple
SDI2 modules in the same enclosure, interconnect wiring makes the installation quicker and
easier than using terminal strip wiring. Each SDI2 module that has an SDI2 interconnect wiring
connector comes with a 12 in (30 cm) interconnect cable.
3.3.2 Points
B9512G control panels provide up to 599 points of protection. B8512G control panels provide
up to 99 points of protection.
Point programming parameters determine the control panel’s response to open and shorted
conditions on the sensor loop for the point. Several options allow individual point
programming to custom-fit the protection to the installation.
The control panel has eight on-board points, points 1 to 8.
The SDI2 bus allows for point expansion. For example, the SDI2 bus supports a combination
of B208 Octo-input Modules, B299 POPEX modules, and a B810 wireless receiver or B820
SDI2 Inovonics Interface Module.
The B600 Retrofit (ZONEX) module allows for connection to a D8125 (D8125MUX, D8125INV)
module for point expansion.
To Next Page
Loading...
