Bosch B9512G - Points Menu Parameters

Control Panels Keypad Installer menu | en 141
Bosch Security Systems, Inc. Installation and System Reference Guide 2016.06 | 08 | F.01U.303.996
7. When the keypad shows Parameter Saved, escape from the menu.
B93x/B94x keypads configuration of Users
1. Enter the installer passcode, and then open the [1] Installer menu.
2. Go to [1] Program > [6] Users menu. The keypad shows the user passcode for the
selected user.
3. Use /[PREV] or /[NEXT] to toggle between user 000 (service user) and user 001 and
go to the user you want to edit.
4. Press [Edit] to change the passcode.
5. Delete existing characters, if necessary, and then enter the new characters.
6. Press [Save].
7. When the keypad shows Parameter Saved, escape from the menu.
20.1.16 [7] Points menu parameters
Use the parameters in this menu to assign a Point Source and a Point Index to each point.
The Point Source parameter assigns the point to a device (on-board, Octo-input, and wireless
are examples). The Point Index (point profile) determines how the point operates.
Point Source selections
Unassigned ZONEX
Octo-input Output
Wireless Keypad
On-board IP Camera*
POPEX Door
*The B426 and the “E” variants do not support IP cameras.
Point Index selections
Assign a Point Index to a point by selecting the Point Index number. The tables below show the Point Index
number and default configuration for each Point Index. You must use RPS to configure the Point Index
parameters..
Point Indexes (point profiles) 1 through 8
Point Index Text defaults (the second language text defaults are blank):
Point Index Number Default Text (first language)
Point Index 1 24-hr Instant on Open/Short
Point Index 2 24-hr Invisible/Sil on Short
Point Index 3 Pull Station
Point Index 4 Smoke Detector
Point Index 5 Smoke Detector w/Verification
Point Index 6 Bell Supervision - D192G
Point Index 7 Part On: Instant