Bosch B9512G - Network > [2] Cellular > (Choose the SDI2 Cellular Module or Plug-In Module)

132 en | Keypad Installer menu Control Panels
2016.06 | 08 | F.01U.303.996 Installation and System Reference Guide Bosch Security Systems, Inc.
2. Go to [1] Program > [2] Network > [1] Ethernet > (choose the bus module or on-board) >
[3] DNS Parameters > [3] Module Hostname. The keypad shows the IPv4 Server Address
current configuration.
3. Press [ENTER] to edit the hostname.
4. Delete existing characters, if necessary, and then enter the new characters.
5. Press [ENTER] to save the programming.
6. When the keypad shows Parameter Saved, escape from the menu.
B93x/B94x keypads configuration of Module Hostname
1. Enter the installer passcode, and then open the [1] Installer menu.
2. Go to [1] Program > [2] Network > [1] Ethernet > (choose the bus module or on-board) >
[3] DNS Parameters > [3] Module Hostname. The keypad shows the DHCP/AutoIP current
configuration.
3. Press [Module Hostname] to edit the hostname
4. Delete existing characters, if necessary, and then enter the new characters.
5. Press [Save] to save the programming.
6. When the keypad shows Parameter Saved, escape from the menu.
20.1.8 [2] Network > [2] Cellular > (choose the SDI2 cellular module or plug-in
module)
You can use a B44x cellular communication module for communication. Plug it directly into the
control panel or use it with a B450 module.
Module 1settings Module 2 settings
SIM APN _______________________________ _______________________________
SIM Username _______________________________ _______________________________
SIM Passcode _______________________________ _______________________________
SIM PIN _______________________________ _______________________________
SIM APN
B91x/B92x keypads configuration of SIM APN
1. Enter the installer passcode, and then open the [1] Installer menu.
2. Go to [1] Program > [2] Network > [2] Cellular > (choose the SDI2 cellular module or
plug-in module) > [1] SIM APN. The keypad shows the current configuration.
3. Press [ENTER] to edit the configuration.
4. Delete existing characters, if necessary, and then enter the new characters.
5. Press [ENTER] to save the programming.
6. When the keypad shows Parameter Saved, escape from the menu.
B93x/B94x keypads configuration of SIM APN
1. Enter the installer passcode, and then open the [1] Installer menu.
2. Go to [1] Program > [2] Network > [2] Cellular > (choose the SDI2 cellular module or
plug-in module) > [1] SIM APN. The keypad shows the DHCP/AutoIP current
configuration.
3. Press [Edit] to edit the configuration.
4. Delete existing characters, if necessary, and then enter the new characters.
5. Press [Save] to save the changes.