Bosch B9512G - Network > [1] Ethernet > (Choose the Bus Module or On-Board) > [2] Address

Control Panels Keypad Installer menu | en 129
Bosch Security Systems, Inc. Installation and System Reference Guide 2016.06 | 08 | F.01U.303.996
20.1.6 [2] Network > [1] Ethernet > (choose the bus module or on-board) > [2]
Address Parameters menu
IPv4 Address
B91x/B92x keypads configuration of IPv4 Address
1. Enter the installer passcode, and then open the [1] Installer menu.
2. Go to [1] Program > [2] Network > [1] Ethernet > (choose the bus module or on-board) >
[2] Address Parameters > [1] IP Address.
3. Press [ENTER] to edit the IP address.
4. Delete the existing number, if necessary, and then enter the new number. Use [PREV] or
[NEXT] to move to a different byte.
5. Press [ENTER] to save the programming.
6. When the keypad shows Parameter Saved, escape from the menu.
B93x/B94x keypads configuration of IPv4 Address
1. Enter the installer passcode, and then open the [1] Installer menu.
2. Go to [1] Program > [2] Network > [1] Ethernet > (choose the bus module or on-board) >
[2] Address Parameters > [1] IP Address.
3. Press [Edit] to edit the IP address.
4. Delete the existing number, if necessary, and then enter the new number. Use /[PREV]
or /[NEXT] to move through the different bytes.
5. Press [Save] to save the programming.
6. When the keypad shows Parameter Saved, escape from the menu.
IPv4 Subnet Mask
B91x/B92x keypads configuration of IPv4 Subnet Mask
1. Enter the installer passcode, and then open the [1] Installer menu.
2. Go to [1] Program > [2] Network > [1] Ethernet > (choose the bus module or on-board) >
[2] Address Parameters > [2] Subnet Mask.
3. Press [ENTER] to edit the subnet mask address.
4. Delete the existing number, if necessary, and then enter the new number. Use [PREV] or
[NEXT] to move to a different byte.
5. Press [ENTER] to save the programming.
6. When the keypad shows Parameter Saved, escape from the menu.
B93x/B94x keypads configuration of IPv4 Subnet Mask
1. Enter the installer passcode, and then open the [1] Installer menu.
2. Go to [1] Program > [2] Network > [1] Ethernet > (choose the bus module or on-board) >
[2] Subnet Mask.
3. Press [IPv4 Subnet Mask] to edit the subnet mask address.
4. Delete the existing number, if necessary, and then enter the new number. Use /[PREV]
or /[NEXT] to move to a different byte, and use the number keys to enter the new
numbers.
5. Press [Save] to save the programming.
6. When the keypad shows Parameter Saved, escape from the menu.