Bosch B9512G - On-Board Ethernet Diagnostic Leds

Control Panels IP communications | en 49
Bosch Security Systems, Inc. Installation and System Reference Guide 2016.06 | 08 | F.01U.303.996
3. In RPS, open the control panel account and click the Connect button. From the Connect
Via drop-down list select IP Direct. Click Connect. Once connected, perform the
necessary tasks, and disconnect when finished.
4. Reconnect the cable used for IP communication, if applicable.
For more information on using AutoIP, refer to AutoIP, page 184.
8.1.3 On-board Ethernet diagnostic LEDs
The control panel includes the following on-board LEDs to assist with troubleshooting the on-
board Ethernet connection.
USB POWER
STATUS
L
I
N
K
ETHERNETUSB
B
A
S
E
T
Improper installation
can be a
fire hazard .
Figure8.8: On-board Ethernet and LEDs
Callout ᅳ Description
1 ᅳ LINK LED (yellow)
2 ᅳ 100BASE-T LED (green)
Refer to the following tables for information on the 100BASE-T and LINK LEDs.
Flash pattern Function
On Steady
Communicating at 100 Mb
Off
Communicating at 10 Mb.
Tab.8.2: 100BASE-T LED descriptions
Flash pattern Function
On Steady
Plugged into an Ethernet network.
Flashing
Communication in progress.