Control Panels Control panel installation | en 31
Bosch Security Systems, Inc. Installation and System Reference Guide 2016.06 | 08 | F.01U.303.996
5 Control panel installation
This section explains how to mount the control panel enclosure, how to mount the control
panel into the enclosure, and provides an overview of how to wire modules to the control
panel.
Enclosure overview
Before you begin, review the overview figure:
Figure5.1: Enclosure and control panel mounting overview
Callout á…³ Description Callout á…³ Description
1 á…³ Mounting skirt attachment hooks (2) 5 á…³ Enclosure mounting holes (5)
2 á…³ Module mounting three-hole pattern (4) 6 á…³ Mounting skirt attachment holes (2)
3 á…³Tamper switch mounting location 7 á…³ Back of the control panel mounting skirt
4 á…³ Mounting skirt screw location (1) 8 á…³ Mounting skirt screw tab
5.1 Install the enclosure
Refer to Enclosures, page 107 to determine if the application requires a specific enclosure.
Installing the enclosure:
1. Remove any knockouts prior to installing the control panel.
2. Mount the enclosure in the desired location. Use all enclosure mounting holes. Refer to
the mounting instructions supplied with the selected enclosure.
3. Pull the wires into the enclosure.
4. Optionally install the supplied point label chart on the inside of the enclosure door.
Notice!
Electromagnetic interference (EMI) can cause problems on long wire runs.
To Next Page
Loading...
