94 en | System wiring diagrams Control Panels
2016.06 | 08 | F.01U.303.996 Installation and System Reference Guide Bosch Security Systems, Inc.
18.1 Power supply side wiring
USB POWER
STATUS
L
I
N
K
ETHERNETUSB
B
A
S
E
T
11
13 14
16
17
19
20
22
12
15
18
21
Quick Flash:
Low
BATTERY STATUS
Slow Flash:
Charging
Off: Normal
On:
Missing
Low 12.1 VDC
Load Shed 10.2 VDC
EARTH GROUND
COMMON
BATTERY (
-
)
+ AUX POWER
BATTERY ( + )
CLASS 2
16.5 VAC 40 VA 60 Hz
TRANSFORMER
10
9
8
7
6
5
4
3
2
1
OUTPUT
B (2)
OUTPUT
A (1)
OUTPUT
C (3)
Do not connect
to a receptacle
controlled by
a switch.
Point 5 Point 6
Point 3 Point 4
Point 1 Point 2 Point 7 Point 8
ON-BOARD POINTS
1 k End-of-line-Resistors Required (P/N 15093130-004),
WARNING!
Multi-Battery
installation requires
Model D122 or D122L
Dual Battery Harness.
Improper installation
can be a fire hazard
.
WARNING!
Incorrect wiring will
damage this
equipment.
Devices powered by
any output must be
supervised.
POWER SUPPL
The Power S
refer to the B
The system is intended
panel has been approv
RevPol.
Battery: Replace every 3 to
5 years with one or two
Model D126 or D1218 12V
Lead Acid Batteries.
WARNING!
To prevent risk of shock,
disconnect AC power and
communication lines before
servicing.
All exte
Require
Voltage Ranges: Open 3.7 - 5.0 VDC,
Owner I
be removed by
POINT 1 COM POINT 2 POINT 3 COM POINT 4 POINT 5 COM POINT 6 POINT 7 COM POINT 8
Figure18.19: Power supply side wiring
Callout á…³ Description Callout á…³ Description
1 á…³ D113 Battery Lead Supervision Module, if required
by local AHJ
8 á…³ To control panel SDI2 wiring
2 á…³ Batteries 9 á…³ D192G Bell Supervision Module
3 á…³ D122/D122L Dual Battery Harness, as required 10 á…³ To OUTPUT A (1) or OUTPUT B (2)
4 ᅳ To supervision point 11 ᅳ 560 Ω, 2 W EOL resistor (P/N: 15-03130-005)
5 á…³ D1640 Transformer 12 á…³ Listed audible signaling devices rated at 12.0 VDC
nominal (do not use vibrating type horns)
6 á…³ B520 Auxiliary Power Supply Module 13 á…³ To earth ground
7 á…³ To powered devices
To Next Page
Loading...
