Bosch B9512G - Network > [1] Ethernet > (Choose the Bus Module or On-Board) > [3] DNS

130 en | Keypad Installer menu Control Panels
2016.06 | 08 | F.01U.303.996 Installation and System Reference Guide Bosch Security Systems, Inc.
Default Gateway
B91x/B92x keypads configuration of Default Gateway
1. Enter the installer passcode, and then open the [1] Installer menu.
2. Go to [1] Program > [2] Network > [1] Ethernet > (choose the bus module or on-board) >
[2] Address Parameters > [3] Default Gateway.
3. Press [ENTER] to edit the gateway.
4. Delete the existing number, if necessary, and then enter the new number. Use [PREV] or
[NEXT] to move to a different byte.
5. Press [ENTER] to save the programming.
6. When the keypad shows Parameter Saved, escape from the menu.
B93x/B94x keypads configuration of Default Gateway
1. Enter the installer passcode, and then open the [1] Installer menu.
2. Go to [1] Program > [2] Network > [1] Ethernet > (choose the bus module or on-board) >
[2] Address Parameters > [3] Default Gateway.
3. Press [Default Gateway] to edit the gateway.
4. Delete the existing number, if necessary, and then enter the new number. Use /[PREV]
or /[NEXT] to move to a different byte.
5. Press [Save] to save the programming.
6. When the keypad shows Parameter Saved, escape from the menu.
HTTP Port Number
B91x/B92x keypads configuration of HTTP Port Number
1. Enter the installer passcode, and then open the [1] Installer menu.
2. Go to [1] Program > [2] Network > [1] Ethernet > (choose the bus module or on-board) >
[2] Address Parameters > [4] HTTP Port Number.
3. Press [ENTER] to edit the port number.
4. Delete the existing number, if necessary, and then enter the new number.
5. Press [ENTER] to save the programming.
6. When the keypad shows Parameter Saved, escape from the menu.
B93x/B94x keypads configuration of HTTP Port Number
1. Enter the installer passcode, and then open the [1] Installer menu.
2. Go to [1] Program > [2] Network > [1] Ethernet > (choose the bus module or on-board) >
[2] Address Parameters > [4] HTTP Port Number.
3. Press [HTTP Port Number] to edit the port number.
4. Delete the existing number, if necessary, and then enter the new number.
5. Press [Save] to save the programming.
6. When the keypad shows Parameter Saved, escape from the menu.
20.1.7 [2] Network > [1] Ethernet > (choose the bus module or on-board) > [3]
DNS Parameters menu
IPv4 Server Address
B91x/B92x keypads configuration of IPv4 Server Address
1. Enter the installer passcode, and then open the [1] Installer menu.