4 en | Table of contents Control Panels
2016.06 | 08 | F.01U.303.996 Installation and System Reference Guide Bosch Security Systems, Inc.
6.1.1 Install the transformer 36
6.2 Secondary (DC) power 37
6.2.1 Install the battery 37
6.2.2 BATTERY STATUS LED 38
6.2.3 Battery maintenance 39
6.2.4 Battery supervision 39
6.2.5 Battery charging circuit float charge 39
6.2.6 Battery discharge and recharge schedule 40
6.3 B520 Auxiliary Power Supply 40
6.3.1 SDI2 address settings 41
6.3.2 Supervision 41
6.3.3 Auxiliary power supply trouble conditions 41
6.3.4 Installation and control panel wiring (B520) 41
6.3.5 Powered device and battery wiring 42
7
Telephone communications 44
7.1 B430 Plug-in Telephone Communicator 44
7.1.1 Supervision 44
7.1.2 Installation and module wiring (B430) 44
7.1.3 Diagnostic LEDs 45
7.2 Phone jack location 45
7.3 Telephone line monitor 46
7.4 Called party disconnect 46
7.5 Communication failure 47
8
IP communications 48
8.1 On-board Ethernet connection 48
8.1.1 Supervision 48
8.1.2 Local RPS programming 48
8.1.3 On-board Ethernet diagnostic LEDs 49
8.2 Conettix Plug-in Cellular Communicators 50
8.2.1 Supervision 50
8.2.2 Installation and module wiring (B44x) 50
8.2.3 Signal strength and diagnostic LEDs 51
8.3 B426 Ethernet Communication Module 52
8.3.1 Address and emulation settings 52
8.3.2 Supervision 52
8.3.3 B426 module faults 52
8.3.4 Local RPS programming 53
8.3.5 Installation and control panel wiring (B426) 53
8.3.6 Diagnostic LEDs 54
8.4 B450 Conettix Plug-in Communicator Interface 55
8.4.1 SDI2 address settings 56
8.4.2 Supervision 56
8.4.3 Installation and control panel wiring (B450) 56
8.4.4 Diagnostic LEDs 57
8.5 Compatible receivers for IP communication 57
9
Keypads, keyswitches, keyfobs and transmitters 59
9.1 Keypads 59
9.1.1 B915 Basic Keypad 59
9.1.2 B920 Two-line Alphanumeric Keypad 59
To Next Page
Loading...
Need help?
General
