R200, R200P, COM2-E Communication Modules
11–4
1070 072 145-102 (01.07) GB
The BUEP03E protocol is a simple ASCII protocol for data transmission via
serial interface between programmable memory controllers and peripheral
devices.
The BUEP64 protocol is used to handle the data exchange between com-
plex or spatially distributed controller systems.
Connectivity options
On the basis of the listed transmission protocols, the R200P provides the fol-
lowing connectivity options:
D PROFIBUS-FMS
D Computer (PC, host computer, etc.)
D CL150, CL200, CL400, CL500
D Scanner
D Printer
Module slots
1234567
Basic unit
GG3-K
PROFIBUS Configurator
To assist with the comfortable, safe and effective creation of project planning
and development data for the PROFIBUS network, the PROFIBUS Configu-
rator software packet (featuring WinDP configuration software, order no.
1070 075 077) can be used with the R200P communication module.
Standard Interfaces function module
With regard to data transmission, a distinction is always made between the
requesting station (RST) initiating the protocol request, and the peripheral
station (PST) responding to the protocol request. In the event that the R200
communication module in the system is to act as the RST in communica-
tions, the integration of the Standard Interfaces function module (order no.
1070 077 901) in the PLC program will be required.
11.1.3 COM2-E Communication Module
The COM2-E communication module comprises one of the CL200 system
modules. It is used to connect the CL200 to other Bosch control units and
other types of intelligent devices. The COM2-E can also be used in combina-
tion with the R200 and R200P in the basic unit of the CL200 controller.
To Next Page
Loading...
