Bosch CL200 - UL-Certification

System Introduction
2–3
1070 072 145-102 (01.07) GB
2.1.1 UL-Certification
The CL200 hardware modules are Underwriters Laboratories (UL) certified
for operation in the United States and Canada. The modules are listed in the
“Product Identity 17YB”.
Designation Order no. Described in
Input module
E 24 V– 16-way
w/ spring loa-
ded terminals
1070 083 383
Chapter 6
Input module
E 24 V– 32-way
w/ spring loa-
ded terminals
1070 083 384
Input module, analog
E20 ana
w/ spring loa-
ded terminals
1070 079 455 Chapter 12
and separate
manual (see
page 1–7)
Output module
A 24 V– / 2 A, 8-way
w/ spring loa-
ded terminals
1070 083 385
Chapter 7
Output module
A 24 V– / 0.5 A, 16-way
w/ spring loa-
ded terminals
1070 083 386
Output module
A 24 V– / 0.5 A, 32-way
w/ spring loa-
ded terminals
1070 083 387
I/O module
E16/A16-0.5 A
w/ spring loa-
ded terminals
1070 079 452 Chapter 8
Output module, analog
A10 ana (4 channels)
w/ spring loa-
ded terminals
1070 079 454
Chapter 13
and separate
Output module, analog
A10 ana (8 Channels)
w/ spring loa-
ded terminals
1070 079 453
manual (see
page 1–7)
BM2-ASI, AS interface bus master 1070 078 284 Chapter 15
and separate
manual (see
page 1–7)
RM2-DP12, remote module 1070 075 814 Chapter 16
and separate
manual (see
page 1–7)
. As a prerequisite for UL approved application, the following connec-
ting cables are required:
D Copper cables rated up to 60/75 _C
D Only Class 1 or similar cables