Bosch CL200 - Programming

System Introduction
2–2
1070 072 145-102 (01.07) GB
Performance range
With 7 different central processing units, the CL200 allows accurate fine–tu-
ning of the controller performance to task related requirements.
D ZE200
Cost effective variant for small and high-speed controller tasks.
D 2 high-speed 32-bit counters
D 3 interrupt inputs
D Centralized system clock
D Function modules for sequential control and diagnostics
D ZE200A
Similar to ZE200, plus
D 4 analog inputs
D 1 analog output
D ZE200M
Similar to ZE200, plus
D MemoryCard
D ZE200AM
Range of functions as on ZE200A and ZE200M
D ZE201
Similar to ZE200, plus
D Second serial interface (COM port)
D ZE200-DP
Similar to ZE200, plus
D Bus master for COMNET-DP
D ZE200A-DP
Range of functions as on ZE200-DP and ZE200A
Hardware configuration
The minimum configuration of the CL200 consists of the following:
D One GG3 or GG3-K module rack
D One NT200 power supply module
D One central processing unit
Functional extension is possible by inserting additional peripheral modules
(intelligent modules or I/O modules).
In the event that more peripheral modules are required, additional modules
can be installed in expansion units.