Panel Controller All functions at a glance | en 17
Bosch Sicherheitssysteme GmbH User Guide 2017.09 | 7.0 | F.01U.258.929
Notice!
Changes may only be made by trained specialist personnel. Competent knowledge of
networking and protocols is essential!
– Change date / time
If starting the panel for the first time enter the current time and date. The setting of the
correct date is a prerequisite for connecting the panel to the Remote Portal server.
– Remote ID:
Enter the Remote ID: required for all Remote Services, e.g. Remote Connect and change
the System ID: if necessary.
3.6 Switching to day or night mode
– Switch to day or night mode
– In day mode: Set the reset time to night mode for the current day.
3.7 Further functions
Further functions -> Change date / time Master password
Remote access Change password
Drill Alarm counters
Change date / time
Change the time and date
Master password
Depending on how the panel is configured, one of these two options will be offered:
– Entering a master password that is valid indefinitely.
This password cannot be changed and is available from the relevant Bosch branch on
request
– Entering a master password that is valid for a specified period of time. This password is
only valid for 24 hours and must first be requested; see Master password, page 89.
After the password has been entered, various options are offered depending on the
configuration; see Operator, page 86.
Drill
Start and terminate a fire drill. During the drill, fire alarms, trouble messages and home
automation alarms are displayed.
Remote Services
– Enable a remote access connection via telephone.
– Block Remote Maintenance until next panel reboot.
– Block Remote Alert until next panel reboot.
Change password
Depending on how the panel is configured, the option of changing the password for every user
is offered.
Alarm counters
– Display the number of internal and external alarm messages and the number of service
alarms that were reported during the lifetime of the panel.
– Reset the alarm counter for each alarm type
To Next Page
Loading...
Need help?
General
