70 en | Maintenance Panel Controller
2017.09 | 7.0 | F.01U.258.929 User Guide Bosch Sicherheitssysteme GmbH
15 Maintenance
This chapter contains information about the following points:
– Walktest: see Maintenance – walktest, page 73
– Changing language display, page 70
– Activate Outputs, page 70
– Activate Transmission Device, page 71
– Detector removal, page 71
– Change device on V.24 Interface, page 71
– History Log: see Maintenance – history log, page 77
– Bypassing/Un-bypassing buzzer, page 72
15.1 Menu overview
Maintenance -> Walktest Change language
Activate outputs Activate transmission device
Remove detector History log
Change device at V.24
interface
Bypass buzzer
15.2 Changing language display
Notice!
The fastest way to change the language display is via a shortcut; see also Changing language
display, page 31.
There are two ways of selecting a different language display:
– Using the menu
– Entering a shortcut; see Changing language display, page 31.
Notice!
After the system starts up following a power cut or battery failure, the default language
defined in the FSP-5000-RPS programming software is set again.
Making a selection via the menu
1. In the start menu, select Maintenance
2. Change language
A list of the languages which can be selected is displayed.
3. Select the language you require.
The displays are displayed in the selected language.
15.3 Activate Outputs
1. In the start menu, select Maintenance
2. Activate outputs
Various element categories are displayed.
3. Select a category or Select by number and enter the number of the element into the
search screen; see also Search Function/Element, page 29
4. Select the required list fields. The list fields are marked.
To Next Page
Loading...
Need help?
General
