Panel Controller Reset | en 93
Bosch Sicherheitssysteme GmbH User Guide 2017.09 | 7.0 | F.01U.258.929
21 Reset
This chapter contains information on how to reset elements.
During resetting, the selected elements are reset to the initial state.
– Event type: Display a list of all message types. The message types can be reset for the
entire Scope.
– Scope: Depending on the Scope set in FSP-5000-RPS, the current panel, all panels in a
group or all the panels in the entire network are reset.
– Logical zone
– Detector
– This panel: All elements of the panel that are not in standby mode are reset
Notice!
If the Scope refers to one panel, the list fields This panel and Scope have the same function.
21.1 Menu overview
Reset -> Event type Scope
Logical zone Detector
This panel
21.2 Resetting elements
To reset a detector or logical zone, for example:
1. In the start menu, select Reset
2. Select the element you require.
3. Select the detector or zone. Refer to Scrolling through lists, page 27 for information on
how to navigate through a list.
4. Select the required list fields.
The list fields are marked.
A list of the detectors or zones is displayed.
5. Select Reset.
The selected elements are reset.
Notice!
As long as the elements are still in the process of resetting, no other entries can be made.
If a list field is marked with an R, the process of resetting is not yet complete for this element:
TEXT R
If an element cannot be reset, it will continue to be displayed in the list.
After the elements have been reset, the standby display is displayed.
To Next Page
Loading...
Need help?
General
