90 en | Further functions Panel Controller
2017.09 | 7.0 | F.01U.258.929 User Guide Bosch Sicherheitssysteme GmbH
2. Master password
3. Enter the master password. Refer to Entering numbers and text, page 29 for information
on how to enter figures or text.
4. Select OK to confirm the entry or Cancel to cancel the operation.
The master password is accepted and the operator is logged in.
The user passwords can now be changed:
Select Change password.
Additional options may be offered. See also Operator, page 86.
20.3.2 Enter the 24-hour master password
The following procedure must be followed in order to obtain a 24-hour master password:
The panel controller generates a number on request. The operator forwards this number to
the relevant NSO by telephone. The NSO gives the user a password which is only valid for 24
hours.
1. In the start menu, select Further functions
2. Master password
3. Create number
4. Request password
A number is displayed.
5. Give the number issued by the system to the Support department.
6. Once you have received the 24-hour password from the Support department, select Enter
password!.
7. Enter the password.
The 24-hour master password is accepted and the user is logged on.
Change password
To change passwords, select Change password.
Additional options may be offered. See also Operator, page 86.
20.4 Remote Services
Remote connection
Notice!
If another menu is called up while the remote connection is still active, Teleservice Active is
displayed. To blank out the text, touch the screen. The text re-appears every 30 seconds for
as long as the remote connection remains active.
To create a remote connection via telephone:
– In the start menu, select Further functions
– Remote access
– Enable call
The system can now be called from remote. Afterwards, the connection is disconnected.
– Active is displayed when a connection has been made.
To disconnect the connection, select Stop remote access .
Remote Maintenance
To stop the data transmission of Remote Maintenance:
– In the start menu, select Further functions
– Remote Services
– Select Block Remote Maintenance.
The transmission of data to the Remote Portal is stopped until the next restart of the
panel controller.
To Next Page
Loading...
Need help?
General
