94 en | Search Function/Element Panel Controller
2017.09 | 7.0 | F.01U.258.929 User Guide Bosch Sicherheitssysteme GmbH
22 Search Function/Element
This chapter contains information about the following points:
– Searching for function and device description, page 94
– Search element, page 94
22.1 Menu overview
Search function /
element
-> Search function
Go to element
22.2 Searching for function and device description
To search for a function or a device:
1. In the start menu, select Search function / element
2. Search function
A list of all functions and device descriptions is displayed.
Refer to Scrolling through lists, page 27 for information on how to navigate through a list.
3. Select the list field you require.
The submenu of the selected function or device description is displayed.
22.3 Search element
To search for an element which is connected to the system:
1. In the start menu, select Search function / element
2. Go to element
Three different lists are offered. See also Working with lists, page 26.
3. Select a list, e.g. By description.
A list of the detectors is displayed. Refer to Scrolling through lists, page 27 for information
on how to navigate through a list.
4. Select the list field you require.
Different selection fields may be offered for the selected element (e.g. OK, Bypass). What
is displayed depends on:
– the message types (e.g. fault, alarm etc.) that can be assigned to this element.
– the mode (e.g. bypassed, reset etc.) that the selected element is in.
To Next Page
Loading...
Need help?
General
