86 en | Configuration Panel Controller
2017.09 | 7.0 | F.01U.258.929 User Guide Bosch Sicherheitssysteme GmbH
3. Select one of the detector or logical zone lists that are offered.
A list of elements is displayed. Refer to Scrolling through lists, page 27 for information on
how to scroll forward and backward through the list.
Depending on the list you have selected, enter the number or the name of the element
into the search screen, Search Function/Element, page 29.
4. Select the list field you require, e.g. a logical zone in this case.
Two settings are displayed: There is a checkmark in the selection field in front of the
active setting.
5. Select the selection field of the detector sensitivity you require.
A checkmark is set in this field.
6. Select OK to confirm the selection or Cancel to cancel the operation.
The selected detector sensitivity is confirmed for the detector.
19.5 Operator
Depending on whether the same password is used per access level, or whether each user has
a different password, one of the following two options is offered:
If the same password is used per access level:
– Change universal password: The same password can be configured for each access level
in the FSP-5000-RPS programming software. This means that all operators with access
authorization for the second level receive the same password, for example. The password
for access levels two to four can be changed.
If each user uses a different password:
– Change operator data: Change the password for an operator.
– Set default password: Reset a user password to the following number sequence: 000000.
Notice!
The password must contain at least one digit.
19.5.1 Change password
1. In the start menu, select Configuration
2. Operator
3. Change operator data
A list of all operators is displayed. Refer to Scrolling through lists, page 27 for information
on how to scroll forward and backward through a list.
4. Select the list field you require.
5. Enter a new password. Repeat the new password in the bottom field again.
On the display, each digit of the password is indicated with an asterisk so that nobody
else can see the password. Refer to Entering numbers and text, page 29 for information on
how to enter figures or text.
6. Select OK to confirm the entry or Cancel to cancel the operation.
The entry is confirmed.
19.5.2 Change universal password
1. In the start menu, select Configuration
2. Operator
3. Change universal password
4. Depending on the access level for which the password is to be changed, select the list
field you require.
To Next Page
Loading...
Need help?
General
