80 en | Day and night mode Panel Controller
2017.09 | 7.0 | F.01U.258.929 User Guide Bosch Sicherheitssysteme GmbH
18 Day and night mode
This chapter contains information about the following points:
– Switching between day and night mode
– Changing the time for resetting to night mode
The manner in which an incoming alarm is handled depends on whether the system is in day
or night mode; see Fire alarm, page 46.
Caution!
Night mode is the highest security level as every incoming alarm is forwarded to external
stations.
Notice!
Depending on the security level in question, not all detectors can be switched to day mode.
The following symbols on the status bar show which mode the panel is switched to. In the
case of networked panels, a night-/day combination icon is displayed on panels in night mode,
if at least one panel in the network is in day mode.
Standalone Network
Night mode Panel is in night mode All networked panels in the
network scope are in night mode
Day mode Panel is in in day mode -
Night-/ day
combination
- Panel is in night mode but at
least one other panel in the
network scope is in daymode
Notice!
Please note that following a transmission fault it may be necessary to synchronize the day/
night mode of the other panels manually in order for the current mode to be displayed
correctly.
18.1 Switching between day and night mode
Notice!
Depending on the programming, the panel automatically switches from day to night mode at
the preset time.
There are two ways to switch between day and night mode:
– Switching over via the menu
– Switching via the status bar
Switching over via the menu
Depending on the mode to which the panel is switched, Switch to day mode or Switch to
night mode is displayed in the start menu.
1. The panel is in night mode: Select Switch to day mode to switch to day mode:
To Next Page
Loading...
Need help?
General
