Panel Controller Operating principle | en 31
Bosch Sicherheitssysteme GmbH User Guide 2017.09 | 7.0 | F.01U.258.929
This takes the cursor to the next free character and you can continue with entering the next
letter.
5.9.1 Changing an entry
1. In order to change a number, press the "left arrow" or "right arrow" keys until the cursor
marks the number in the search screen that is to be replaced.
2. To overwrite the marked number, press the key with the required number until the
number you require is displayed in the search screen.
5.9.2 Deleting all numbers
1. In order to delete all numbers in the search screen, press the "left arrow" key until the
cursor marks the first number.
2. Enter a new number using the number pad.
All numbers up to the digit entered are deleted.
3. If you wish to, continue entering the numbers.
5.10 Changing language display
There are two ways to select another language display:
– By entering a shortcut
– Via a menu selection; see Changing language display, page 70.
5.10.1 Entering key combination
1. Select the "home" key immediately followed by the 1 on the alphanumeric keypad. A
query window will appear.
2. Select OK to confirm the entry or Cancel to cancel the operation.
A list of the existing languages is displayed.
3. Select the language you require.
The displays will now be shown in the selected language.
Notice!
After the system starts up following a power cut or battery failure, the default language
defined in the FSP-5000-RPS programming software is set again.
5.11 Switching between status bars
The status bar offers further functions, display and selection options.
If the "double arrow" symbol is displayed in the status bar, it is possible to switch to the
status bar of the start menu. To do this, press the "double arrow" key on the membrane
keypad.
5.12 Standby
If no longer operated, the panel controller switches to standby mode after 5 minutes. The
touch screen backlighting switches off. To quit standby mode, touch any part of the touch
screen.
5.13 Logical and physical addressing
When addressing elements, there is a distinction between logical and physical addressing:
To Next Page
Loading...
Need help?
General
