Panel Controller Day and night mode | en 81
Bosch Sicherheitssysteme GmbH User Guide 2017.09 | 7.0 | F.01U.258.929
2. Confirm your selection with Switch to day mode.
The panel is switched to day mode.
To cancel the operation, select Cancel.
If the panel is in day mode, select Switch to night mode to switch to night mode.
Switching via the status bar
The panel is in night mode. To switch it to day mode:
4 Press
or
4 Select Switch to day mode to confirm the request or Cancel to cancel the operation.
The panel is in day mode. To switch it to night mode:
4 Press
4 Select Switch to night mode to confirm the selection or Cancel to cancel the operation.
18.2 Showing details
It is possible both in day and night mode to display a list of all logical zones on the panel that
are currently switched to day mode.
To display a list of all detector groups in day mode
1. In the start menu, select Switch to day mode or Switch to night mode, depending on
which mode the panel is currently in, or select the "day mode" or "night mode" icon on
the status bar.
2. Select Show details.
A list of all logical zones that are switched to day mode is displayed.
18.3 Changing the time for resetting to night mode
Caution!
After the system starts up following a power cut or battery failure, the default set back time
in FSP-5000-RPS is reset.
Notice!
Depending on the configuration, the set back time can be changed. It is only possible to make
a change for the current day. It is only possible to make a change if a specified time has
already been set for the current day in the programming software.
The set back time can be changed in day or night mode.
To change the time for resetting in night mode:
4 On the status bar, select
or
or
In the start menu, select Switch to day mode.
1. Select Change time.
To Next Page
Loading...
Need help?
General
