62 en | Diagnostics Panel Controller
2017.09 | 7.0 | F.01U.258.929 User Guide Bosch Sicherheitssysteme GmbH
2. Select the required list fields.
The list fields are marked.
3. Select Yes.
A list of various data types is displayed.
4. Select the field you require.
The field is marked.
The data of each selected element is requested.
5. Select Start.
To cancel the operation, select Cancel.
A status bar appears.
6. Select the arrow keys to display further information.
7. Select Refresh to update data if necessary.
14.3 Modules
To display diagnostic information about a particular module:
1. In the start menu, select Diagnostics
2. Modules
Two different lists are offered.
3. Select a list, e.g. By number. Refer to chapter Scrolling through lists, page 27 for
information on how to scroll through a list.
A list of all used modules is displayed.
4. Select the list field you require.
A list of various information options is displayed:
– Module passport
– Module Compatibility
– Module status
For an LSN module, the following selection fields are also offered:
– Module status and counters
– Reset counters
5. Select the information option you require, e.g. Module status.
Diagnostic information about the module status is displayed.
A status bar appears.
6. Select the arrow keys to display further information.
7. Select Refresh to update data if necessary.
14.4 Hardware
14.4.1 Address cards
To display information about the released addresses:
1. Select Diagnostics in the start menu.
2. Hardware
3. Address cards
The information is displayed.
A status bar appears.
4. Select the arrow keys to display further information.
5. Select Refresh to update data if necessary.
14.4.2 Display
Five different functions are offered:
– LED test: Test the LED display.
– Key test: Test the operativeness of the membrane keypad.
To Next Page
Loading...
Need help?
General
