Panel Controller Networked panels | en 35
Bosch Sicherheitssysteme GmbH User Guide 2017.09 | 7.0 | F.01U.258.929
This icon is displayed on those networked panels, in this example panel B, with which another
panel, in this case A, has established an isolated connection.
A panel B, with which a panel A has established an isolating connection, cannot be operated
from another panel C.
However, a panel C can establish a restricted connection with a panel B that is already being
operated from a panel A.
If the connection is restricted, a panel can only be operated in read-only mode. All dialogs can
be accessed in read-only mode and the history log can be read out.
This icon is displayed if there is a restricted connection with a networked panel.
1. In order to convert a restricted connection into an isolating connection, select the
"Network" key.
2. Respond to the query concerning the termination of the connection with "No".
3. Select the isolated panels you require from the list.
4. Select OK and confirm the subsequent query with OK.
The isolation of the panel is lifted and a restricted connection is established.
To Next Page
Loading...
Need help?
General
