11-15
Bosch Security Systems 05/10 BLCC100I
Solution 16
plus
Installation Manual System Programming
3) Open and close each zone that needs to be tested. A zone that
has been successfully tested will no longer scroll on the keypad
display. When all zones have been tested, the keypad will
display.
All zones have been
Successfully tested
Press OK or MENU
4) Press [OK] to save and exit or press [MENU] to exit without
saving.
System > System Testing >
Battery Test
-
-
MENU 7-9-1
This menu allows you to test the panels standby battery. The
battery test will last about two minutes and the keypad will
display the voltage of the battery during the test.
1) Press [MENU] + [7] + [9] + [1]. The keypad will display the
battery voltage whilst under test:
Battery test in progress.
Please wait..
Voltage = 13.4V
To Go Back, Press OK
2) If the battery has passed the test, the keypad will display:
Battery Test Passed
Press OK to continue
To Go Back, Press OK
3) If the battery has failed the test, the keypad will display:
Battery Test Failed.
Please Call For Service.
To Go Back, Press OK
4) Press [OK] to exit.
» » E N D O F S E C T I O N « «
To Next Page
Loading...
