151
Insert effect parameter functions
Appendices
Delay
This creates a thicker sound by applying a delayed sound to
the direct sound.
Effect On/Off OFF, ON
This parameter turns the delay effect on/off.
Type
This Parameter selects the type of delay.
SINGLE:
This is a simple delay.
TAP:
The delayed sound is panned across the left and right
channels. This will be effective when stereo output is used.
Delay Time
SINGLE: 1–1400 ms, TAP: 1–700 ms
This parameter adjusts the delay time (i.e., the interval for
which sound is delayed).
Feedback 0–100
This parameter adjusts the amount of feedback. Changing
the amount of feedback causes the number of time the
delayed sound is repeated to change as well.
Effect Level 0–120
Adjusts the volume of the delay sound.
Distance
Microphones have a characteristic which causes the low
frequency range to be boosted when the sound source is
nearby. This is called the proximity effect.
This setting simulates this phenomenon.
Effect On/Off OFF, ON
This setting turns Distance on/off.
Prox.Fx -12 dB–+12 dB
Microphones have a characteristic which causes the low
frequency range to be boosted when the sound source is
nearby. Adjust the low frequency response that is affected by
the mic distance from the sound source. Adjustment in the [+]
direction will move the mic closer to the sound source, and in
the [-] direction will move it away from the sound source.
Time 0–3000 cm
This simulates the time difference due to distance from the
sound source.
Doubling
By adding a slightly time-delayed sound to the direct sound,
this produces the impression that multiple sources are
sounding together (a “doubling” effect). Best results will be
achieved when stereo output is used.
* This effect can be used when the Modulation “Effect Type”
parameter is set to “DOUBL’N.”
Effect On/Off OFF, ON
This parameter turns the doubling effect on/off.
Delay Time 0.5–50.0 ms
This parameter adjusts the delay time (i.e., the interval for
which sound is delayed).
Separation -100–+100
Adjusts the diffusion. The panning of the direct sound and
effect sound can be spread to left and right. This will be
effective when stereo output is used.
Effect Level 0–120
This adjusts the volume of the delay sound.
Enhancer
By adding sounds which are out-of-phase with the direct
sound, this effect enhances the definition of the sound, and
pushes it to the forefront.
Effect On/Off OFF, ON
This parameter turns the enhancer effect on/off.
Sensitivity 0–100
Adjusts the manner in which the enhancer will be applied
relative to the input signals.
Frequency 1.0–10.0 kHz
Adjusts the frequency at which the enhancer effect will begin
to be applied. The effect will be made apparent in the
frequencies above the frequency set here.
Mix Level 0–100
Adjusts the amount of phase-shifted sound of the range set
by “Frequency” that is to be mixed with the input.
Low Mix Level 0–100
Adjusts the amount of phase-shifted sound of the lower
range that is to be mixed with the input. The frequency range
in which the effect is applied is fixed.
To Next Page
