75
Advanced Use
Canceling a recording or editing procedure—Undo/Redo
There may be times when the recording you make of a
performance may not turn out as you wish, or the settings
you make for an editing operation are incorrect, and you
want to reverse what you have done. At these times, you can
use the “Undo function.”
The Undo function reverses the action you have just
performed and returns you to the status you were in
beforehand. To reverse an Undo, you must use the “Redo
function.”
For example, suppose you are punching in to loop record
and record over the same location twice. To undo the
recording you just performed and return to the first
recording, you would use the Undo function.
To then reverse the Undo and return to the condition that
you were in immediately after the second recording, you
would use the Redo function.
Furthermore, you can continue repeating Undo to review the
sequence of operations you have made thus far.
* After you have performed an Undo, if you perform any
recording, select another song, or perform any action that
saves data to memory, you’ll no longer be able to perform the
Redo.
* Undos only affect audio data recorded to the tracks. You
cannot undo changes made to parameter settings, or data other
than audio data.
* Keep in mind that the history of all operations you’ve carried
out with respect to the recorded data will be cleared as soon as
you carry out a Song Optimize (p. 78). This means that once
you execute Song Optimize, you’ll no longer be able to perform
an undo. Also be sure to note that if you carry out an undo
after saving a song that has undergone Song Optimize, all of
the recorded data will be erased.
Reversing the last operation
(Undo)
1. Press [UNDO/REDO].
“Undo?” appears, and the UNDO and REDO icons are
displayed.
fig.R11-01
2. Move the cursor to “UNDO,” and press [ENTER].
When you press [YES], the data will be returned to the
state prior to the last-performed recording or editing
operation.
If you decide not to Undo, press [NO].
3. To go back even further, to other stages in your editing
process, simply repeat Steps 1 and 2.
Each time Steps 1 and 2 are repeated, the BR-1180/
1180CD reverts to the state it was in immediately
preceding the current state. Once you reach the point
where no more Undos can be carried out, the UNDO
icon disappears from the screen.
* The history is capable of up to approximately 10,000 Undos.
Canceling the Undo—Redo
To reverse the Undo you just executed, perform a Redo.
* When a Redo is possible, the “ ” appears beside the song
name of the top screen.
1. Press [UNDO/REDO].
The UNDO and REDO icons are displayed.
2. Move the cursor to “REDO,” and press [ENTER].
When you press [YES], the last-performed Undo
operation will be cancelled.
If you decide not to Undo, press [NO].
fig.R11-02
3. To reverse another Undo, repeat Steps 1 and 2.
Each time Steps 1 and 2 are repeated, another Undo is
reversed. When all of the Undos have been reversed, and
the BR-1180/1180CD is restored to the state it was in
right before you issued the first Undo command, no
more Redos can be carried out, so the REDO icon
disappears from the screen.
To Next Page
