Brigade Backeye 360 Select - Configuring the Parking Guide

36
To exit the menu and save the changes, press the MENU button on
the remote control once to return to the menu home screen and
then again to exit.
Note: there is a short delay when exiting the menu as the system
saves the changes that have been made. Wait approx. 10 seconds
for the system to exit the menu.
Restart the system to “activate” the changes (turn vehicle ignition on/off).
Configuring the Parking Guide
To change the Parking Guide settings, enter the OSD SETUP
menu by pressing the MENU button and pressing OK on the
SETUP icon.
Press the TAB down button 5 times to select the Parking Guide
option.
Use the arrow buttons to change the setting for the Parking Guide.
The options here are:
• On – parking guide is always on when a rear view image is
shown
• Rear Gear – parking guide only displays when the rear gear
is active
• Off – parking guide is never shown