The options for this are:
• Default View – returns the to the Default View after View Select Button is pressed (after 10s delay) or after a
triggered response..
• Previous View – remains on the view that is displayed when View Select Button is pressed. When a trigger
becomes active the system will automatically switch to the triggered view, once the trigger is removed the
system will return to the previous view that was displayed by the View Select Button. The system will always
display the Default View at switch on.
Note: Triggers always have priority over the View Select Button.
To exit the menu and save the changes, press the MENU button
on the remote control once to return to the menu home screen and
then again to exit.
Note: there is a short delay when exiting the menu as the system
saves the changes that have been made. Wait approx. 10 seconds
for the system to exit the menu.
Configuring the Speed Trigger
To enable and configure the Speed Signal Trigger, enter the OSD SETUP menu by pressing the
MENU button and pressing OK on the SETUP icon.
The Speed Trigger settings are on the second page of the OSD
SETUP menu. Press the TAB up button to select the next page
icon and press the OK button.
(Alternatively, press the TAB down button 11 times)
By default, the Speed Signal Trigger is set to OFF, to enable this
use the arrow buttons on the remote control to change this to ON.
To Next Page
Loading...
